







Tamegar PM56T spotting press
Technical specification
| Category | Presses with mechanical driving |
| Make | TAMEGAR |
| Condition | Used |
| Location | Spain |
Description
Hydraulic press for spotting and trying out moulds
The Tamegar PM 56 T is a hydraulic spotting and stamping press made by Tamegar in Elche (Alicante). It is used in mould and die shops to close, adjust and check the contact between the two halves of a mould, and for small stamping jobs.
Key strengths of the machine
A spotting or die-setting press closes the mould under controlled pressure away from the injection machine or production press, which saves machine time and makes it easier to rework the closing surfaces. This unit has hydraulic drive, with a pressure gauge on the control desk, mesh guards with doors and its own electrical cabinet.
Configuration of this unit
Model: PM 56 T, machine no. 509, year 1999 (plate)
Type: spotting and stamping
Force: 56 t
Stroke: 700 mm
Table: 1,000 x 700 mm
Daylight: 200 to 700 mm
Maximum hydraulic pressure: 150 bar; power 4 kW; 380 V (plate)
Weight: 2,700 kg
Typical applications
Spotting and checking the closure of plastic injection, footwear and rubber moulds, die assembly, light drawing, pressing and small stamping jobs.
See it at Ferrotall
The machine is at our premises in Monforte del Cid (Alicante), where you can visit it; contact us to see it running or to receive a video. Our own service engineers take care of transport, installation and commissioning.
The Tamegar PM 56 T is a hydraulic spotting and stamping press made by Tamegar in Elche (Alicante). It is used in mould and die shops to close, adjust and check the contact between the two halves of a mould, and for small stamping jobs.
Key strengths of the machine
A spotting or die-setting press closes the mould under controlled pressure away from the injection machine or production press, which saves machine time and makes it easier to rework the closing surfaces. This unit has hydraulic drive, with a pressure gauge on the control desk, mesh guards with doors and its own electrical cabinet.
Configuration of this unit
Model: PM 56 T, machine no. 509, year 1999 (plate)
Type: spotting and stamping
Force: 56 t
Stroke: 700 mm
Table: 1,000 x 700 mm
Daylight: 200 to 700 mm
Maximum hydraulic pressure: 150 bar; power 4 kW; 380 V (plate)
Weight: 2,700 kg
Typical applications
Spotting and checking the closure of plastic injection, footwear and rubber moulds, die assembly, light drawing, pressing and small stamping jobs.
See it at Ferrotall
The machine is at our premises in Monforte del Cid (Alicante), where you can visit it; contact us to see it running or to receive a video. Our own service engineers take care of transport, installation and commissioning.
Listing text machine-translated into English from Spanish. Make and model are as supplied by the dealer.
Imported from the Ferrotall Maquinas Herramienta S.L. stock feed (https://www.ferrotall.com/products.json). Source listing: https://www.ferrotall.com/en/products/tamegar-pm56t-spotting-press
