Home / Metal forming / Bend- straight- reducing of pipes bars profiles / Section bender Casanova FC.1





Section bender Casanova FC.1
Technical specification
| Category | Bend- straight- reducing of pipes bars profiles |
| Make | CASANOVA |
| Condition | Used |
| Location | Spain |
Description
Casanova FC-1 section bender
Three-roll section bender for bending tube, angle, flat bar and other cold-rolled sections. The machine plate states type FC-1 and the Casanova brand.
Model features
According to the manufacturer's catalogue sheet (FC series, no serial no., not attributed to this unit), the FC-01 model is stated to have fully hydraulic drive with overload protection and a 3 HP hydraulic power unit, with a working speed of 4.5 m/min and 60 mm diameter shafts.
For the FC-01 the catalogue gives standard rolls of 160 mm diameter; this is a catalogue figure, not measured on this unit. The catalogue shows the FC-01 without a remote control console, whereas this unit has one, so the catalogue should be taken as a guide only.
Configuration of this unit
Three rolls and lever controls on a mobile console with wheels.
Two dial gauges on the top.
Worn paintwork with rusty areas on the housing; the actual condition cannot be assessed from the photos.
Plate: type FC-1, Casanova brand.
Typical applications
Making rings, arches and structures from tube, angle, flat bar and other sections: metal fabrication, railings, structures, staircases and metal furniture.
See it at Ferrotall
The machine is at our premises in Monforte del Cid (Alicante), where you can visit it; contact us to see it running or to receive a video. Our own service engineers take care of transport, installation and commissioning.
Three-roll section bender for bending tube, angle, flat bar and other cold-rolled sections. The machine plate states type FC-1 and the Casanova brand.
Model features
According to the manufacturer's catalogue sheet (FC series, no serial no., not attributed to this unit), the FC-01 model is stated to have fully hydraulic drive with overload protection and a 3 HP hydraulic power unit, with a working speed of 4.5 m/min and 60 mm diameter shafts.
For the FC-01 the catalogue gives standard rolls of 160 mm diameter; this is a catalogue figure, not measured on this unit. The catalogue shows the FC-01 without a remote control console, whereas this unit has one, so the catalogue should be taken as a guide only.
Configuration of this unit
Three rolls and lever controls on a mobile console with wheels.
Two dial gauges on the top.
Worn paintwork with rusty areas on the housing; the actual condition cannot be assessed from the photos.
Plate: type FC-1, Casanova brand.
Typical applications
Making rings, arches and structures from tube, angle, flat bar and other sections: metal fabrication, railings, structures, staircases and metal furniture.
See it at Ferrotall
The machine is at our premises in Monforte del Cid (Alicante), where you can visit it; contact us to see it running or to receive a video. Our own service engineers take care of transport, installation and commissioning.
Listing text machine-translated into English from Spanish. Make and model are as supplied by the dealer.
Imported from the Ferrotall Maquinas Herramienta S.L. stock feed (https://www.ferrotall.com/products.json). Source listing: https://www.ferrotall.com/en/products/section-bender-casanova-fc-1
