

















Machining centre Quaser MV 204IIE/10
Technical specification
| Category | Machining centres |
| Make | QUASER |
| Condition | Used |
| Location | Spain |
Description
Quaser MV 204IIE/10 vertical machining centre
Quaser vertical machining centre, model MV 204IIE/10 according to the marking on the front, with full enclosure and double door. It is suited to machining steel, aluminium and cast iron parts in toolmaking, mould and subcontract machining shops.
Key strengths of the series
According to listings for other MV 204 II units, the series has table travels of 1,020, 610 and 560 mm in X, Y and Z, with a BT40 spindle of up to 10,000 rpm and Fanuc control; these are series data, not confirmed on this unit.
Configuration of this unit
Marked model: MV 204IIE/10
Spindle range, as marked: 750-10,000 min-1, constant power
Axis acceleration, as marked: 7 m/s2
BIG-PLUS label visible on the front
Control console with screen and swivelling operator panel
T-slotted table
Typical applications
Milling, drilling and tapping of prismatic parts in short or medium batches.
See it at Ferrotall
The machine is at our premises in Monforte del Cid (Alicante), where you can visit it; contact us to see it running or to receive a video. Our own service engineers take care of transport, installation and commissioning.
Quaser vertical machining centre, model MV 204IIE/10 according to the marking on the front, with full enclosure and double door. It is suited to machining steel, aluminium and cast iron parts in toolmaking, mould and subcontract machining shops.
Key strengths of the series
According to listings for other MV 204 II units, the series has table travels of 1,020, 610 and 560 mm in X, Y and Z, with a BT40 spindle of up to 10,000 rpm and Fanuc control; these are series data, not confirmed on this unit.
Configuration of this unit
Marked model: MV 204IIE/10
Spindle range, as marked: 750-10,000 min-1, constant power
Axis acceleration, as marked: 7 m/s2
BIG-PLUS label visible on the front
Control console with screen and swivelling operator panel
T-slotted table
Typical applications
Milling, drilling and tapping of prismatic parts in short or medium batches.
See it at Ferrotall
The machine is at our premises in Monforte del Cid (Alicante), where you can visit it; contact us to see it running or to receive a video. Our own service engineers take care of transport, installation and commissioning.
Listing text machine-translated into English from Spanish. Make and model are as supplied by the dealer.
Imported from the Ferrotall Maquinas Herramienta S.L. stock feed (https://www.ferrotall.com/products.json). Source listing: https://www.ferrotall.com/en/products/machining-centre-quaser-mv-204iie-10
