














Machining centre Pinnacle LV105
Technical specification
| Category | Machining centres |
| Make | ferrotall-nuevo |
| Condition | Used |
| Location | Spain |
Description
Used Pinnacle LV105 machining centre
The Pinnacle LV105 is a medium-sized vertical machining centre with 1,020 x 560 x 560 mm travels and a 1,200 x 510 mm table, suited to producing mould parts, tooling and mechanical components in steel, aluminium and cast iron.
Strengths
The LV105 specification sheet shown in the photos (it has no serial number, so it only describes the model) mentions linear roller guideways, pneumatic headstock counterbalance and 4th-axis preparation without motor or drive; there is no record that this unit has these features. According to our data sheet, the control is a Fanuc 0i-MF, and the photos show the control console with screen.
Configuration of this unit
Model: LV105
Control: Fanuc 0i-MF (according to our data sheet)
X, Y, Z travels: 1,020 x 560 x 560 mm
Table: 1,200 x 510 mm
BBT-40 taper; spindle up to 12,000 rpm
24-pocket tool changer
Through-tool coolant
Swarf conveyor (visible in the photos)
Year: 2016; overall dimensions: 2,600 x 2,650 x 2,280 mm
Typical applications
Machining of moulds, dies, tooling parts, automotive components and general engineering parts.
See it at Ferrotall
The machine is at our premises in Monforte del Cid (Alicante), where you can visit it; contact us to see it running or to receive a video. Our own service engineers take care of transport, installation and commissioning.
The Pinnacle LV105 is a medium-sized vertical machining centre with 1,020 x 560 x 560 mm travels and a 1,200 x 510 mm table, suited to producing mould parts, tooling and mechanical components in steel, aluminium and cast iron.
Strengths
The LV105 specification sheet shown in the photos (it has no serial number, so it only describes the model) mentions linear roller guideways, pneumatic headstock counterbalance and 4th-axis preparation without motor or drive; there is no record that this unit has these features. According to our data sheet, the control is a Fanuc 0i-MF, and the photos show the control console with screen.
Configuration of this unit
Model: LV105
Control: Fanuc 0i-MF (according to our data sheet)
X, Y, Z travels: 1,020 x 560 x 560 mm
Table: 1,200 x 510 mm
BBT-40 taper; spindle up to 12,000 rpm
24-pocket tool changer
Through-tool coolant
Swarf conveyor (visible in the photos)
Year: 2016; overall dimensions: 2,600 x 2,650 x 2,280 mm
Typical applications
Machining of moulds, dies, tooling parts, automotive components and general engineering parts.
See it at Ferrotall
The machine is at our premises in Monforte del Cid (Alicante), where you can visit it; contact us to see it running or to receive a video. Our own service engineers take care of transport, installation and commissioning.
Listing text machine-translated into English from Spanish. Make and model are as supplied by the dealer.
Imported from the Ferrotall Maquinas Herramienta S.L. stock feed (https://www.ferrotall.com/products.json). Source listing: https://www.ferrotall.com/en/products/machining-centre-pinnacle-lv105
