





Lathe Pinacho S90/200
Technical specification
| Category | Turning (Automatics, Borers and Lathes) |
| Make | PINACHO |
| Condition | Used |
| Location | Spain |
Description
Pinacho S-90/200 centre lathe from 1997
The Pinacho S-90/200 is a conventional centre lathe built by Metosa (Castejón del Puente, Huesca) in 1997, according to its plate. This unit has 1,150 mm between centres, 400 mm swing over bed and 595 mm in the gap.
Key strengths
The headstock dial shows ranges A, B and C with speeds up to 2,200 rpm, and below it are the thread tables for metric, Whitworth, module and diametral pitch. The machine has a front guard with a window and an emergency stop button on the apron.
Configuration of this unit
Model: S90-200, no. 31724, year 1997 (CE plate)
Manufacturer: Metosa, Castejón del Puente (Huesca)
Distance between centres: 1,150 mm
Spindle bore: 52 mm
Swing over bed: 400 mm
Swing in gap: 595 mm
Swing over cross slide: 210 mm
Bed width: 300 mm
Speeds: 40 to 2,200 rpm (according to data sheet)
Three-jaw chuck and four-way toolpost
Typical applications
Turning, facing, drilling and threading of shafts, bushes and maintenance parts in general machining and toolmaking workshops.
See it at Ferrotall
The machine is at our premises in Monforte del Cid (Alicante), where you can visit it; contact us to see it running or to receive a video. Our own service engineers take care of transport, installation and commissioning.
The Pinacho S-90/200 is a conventional centre lathe built by Metosa (Castejón del Puente, Huesca) in 1997, according to its plate. This unit has 1,150 mm between centres, 400 mm swing over bed and 595 mm in the gap.
Key strengths
The headstock dial shows ranges A, B and C with speeds up to 2,200 rpm, and below it are the thread tables for metric, Whitworth, module and diametral pitch. The machine has a front guard with a window and an emergency stop button on the apron.
Configuration of this unit
Model: S90-200, no. 31724, year 1997 (CE plate)
Manufacturer: Metosa, Castejón del Puente (Huesca)
Distance between centres: 1,150 mm
Spindle bore: 52 mm
Swing over bed: 400 mm
Swing in gap: 595 mm
Swing over cross slide: 210 mm
Bed width: 300 mm
Speeds: 40 to 2,200 rpm (according to data sheet)
Three-jaw chuck and four-way toolpost
Typical applications
Turning, facing, drilling and threading of shafts, bushes and maintenance parts in general machining and toolmaking workshops.
See it at Ferrotall
The machine is at our premises in Monforte del Cid (Alicante), where you can visit it; contact us to see it running or to receive a video. Our own service engineers take care of transport, installation and commissioning.
Listing text machine-translated into English from Spanish. Make and model are as supplied by the dealer.
Imported from the Ferrotall Maquinas Herramienta S.L. stock feed (https://www.ferrotall.com/products.json). Source listing: https://www.ferrotall.com/en/products/lathe-pinacho-s90-200
