





Lathe Lacfer CR1
Technical specification
| Category | Turning (Automatics, Borers and Lathes) |
| Make | LACFER |
| Condition | Used |
| Location | Spain |
Description
Lacfer CR1 centre lathe with 1,500 mm between centres
The Lacfer CR1 is a mid-sized conventional centre lathe for general workshop jobs. Our data sheet lists 1,500 mm between centres, 440 mm swing over bed and 250 mm over the cross slide.
Key strengths
The photos show a lathe with a speed and threading gearbox on the headstock, an apron with handwheel and power feeds, and a tailstock with a drill chuck in the quill, which allows drilling on the workpiece axis without changing machine.
Configuration of this unit
Model: CR1 (according to our data sheet), make Lacfer
Distance between centres: 1,500 mm
Spindle bore: 41 mm
Swing over bed: 440 mm
Swing over cross slide: 250 mm
Bed width: 335 mm
Three-jaw chuck
Tailstock with drill chuck
Square toolpost
Typical applications
Turning, facing, drilling and threading of shafts, bushes and maintenance parts in general machining and repair workshops.
See it at Ferrotall
The machine is at our premises in Monforte del Cid (Alicante), where you can visit it; contact us to see it running or to receive a video. Our own service engineers take care of transport, installation and commissioning.
The Lacfer CR1 is a mid-sized conventional centre lathe for general workshop jobs. Our data sheet lists 1,500 mm between centres, 440 mm swing over bed and 250 mm over the cross slide.
Key strengths
The photos show a lathe with a speed and threading gearbox on the headstock, an apron with handwheel and power feeds, and a tailstock with a drill chuck in the quill, which allows drilling on the workpiece axis without changing machine.
Configuration of this unit
Model: CR1 (according to our data sheet), make Lacfer
Distance between centres: 1,500 mm
Spindle bore: 41 mm
Swing over bed: 440 mm
Swing over cross slide: 250 mm
Bed width: 335 mm
Three-jaw chuck
Tailstock with drill chuck
Square toolpost
Typical applications
Turning, facing, drilling and threading of shafts, bushes and maintenance parts in general machining and repair workshops.
See it at Ferrotall
The machine is at our premises in Monforte del Cid (Alicante), where you can visit it; contact us to see it running or to receive a video. Our own service engineers take care of transport, installation and commissioning.
Listing text machine-translated into English from Spanish. Make and model are as supplied by the dealer.
Imported from the Ferrotall Maquinas Herramienta S.L. stock feed (https://www.ferrotall.com/products.json). Source listing: https://www.ferrotall.com/en/products/lathe-lacfer-cr1
