








Lathe Jashone M-180-E
Technical specification
| Category | Turning (Automatics, Borers and Lathes) |
| Make | JASHONE |
| Condition | Used |
| Location | Spain |
Description
Centre lathe Jashone M-180-E
The M-180-E is a centre lathe with 1.000 mm between points, 380 mm in diameter admitted on bade and spindle hole of 52 mm. On the front are Jashone and Jarbe signs. It is used in general machining and maintenance workshop.
Strengths
The centre lathe allows cylinder, refrained, threaded and drilled with manual tool, with a range of rpm from 32 to 2.000 and table of threaded steps in the head. The digital end display facilitates custom work. (Z5Z.)
Configuration of this unit
Model: M-180-E
Distance between points: 1.000 mm
Diameter on block: 380 mm; on car: 200 mm
spindle Hole: 52 mm; bench width: 275 mm
Speed: 32 to 2.000 rpm; main engine: 3 kW
Heidenhain digital display of 3 axes
Portaherramientas in the car and tailstock with point
Typical applications
Manufacture of axes, spare parts, industrial repair and maintenance, and short series of turned parts.
See in Ferrotall
The lathe is located in our facilities of Monforte del Cid (Alicante), where you can visit it; contact us to see it running or receive a video. Our own technical service is responsible for transport, installation and start-up.
The M-180-E is a centre lathe with 1.000 mm between points, 380 mm in diameter admitted on bade and spindle hole of 52 mm. On the front are Jashone and Jarbe signs. It is used in general machining and maintenance workshop.
Strengths
The centre lathe allows cylinder, refrained, threaded and drilled with manual tool, with a range of rpm from 32 to 2.000 and table of threaded steps in the head. The digital end display facilitates custom work. (Z5Z.)
Configuration of this unit
Model: M-180-E
Distance between points: 1.000 mm
Diameter on block: 380 mm; on car: 200 mm
spindle Hole: 52 mm; bench width: 275 mm
Speed: 32 to 2.000 rpm; main engine: 3 kW
Heidenhain digital display of 3 axes
Portaherramientas in the car and tailstock with point
Typical applications
Manufacture of axes, spare parts, industrial repair and maintenance, and short series of turned parts.
See in Ferrotall
The lathe is located in our facilities of Monforte del Cid (Alicante), where you can visit it; contact us to see it running or receive a video. Our own technical service is responsible for transport, installation and start-up.
Listing text machine-translated into English from Spanish. Make and model are as supplied by the dealer.
Imported from the Ferrotall Maquinas Herramienta S.L. stock feed (https://www.ferrotall.com/products.json). Source listing: https://www.ferrotall.com/en/products/torno-jashone-m-180-e
