






Grinding machine Kair TMA 800X400
Technical specification
| Category | Grinders |
| Make | KAIR |
| Condition | Used |
| Location | Spain |
Description
Grinding machine tangential Kair TMA-800 × 400
The Kair TMA-800 × 400 is a grinding machine of flat surfaces of tangential type, with a hydraulically activated alternative motion table. It is used to obtain planitude, parallelism and good finish in tempered or untempered steel parts: mould and matrix plates, guides, recesses, flanges, blades and utilages.
Strong points of this machine
In the tangential rectification the grinding wheel works with its periphery, which allows narrow tolerances of planitude and a fine finish. The hydraulic drive of the table gives a smooth and adjustable displacement. The panel of this unit includes automatic selector (AUT) and transverse advance and grinding wheel. descent controls (Z7Z.)
Configuration of this unit
Model: TMA-800 × 400
Maximum grinding area: 800 × 400 mm
travel longitudinal (X): 940 mm
grinding wheel: 250 × 40 mm
Table operation: hydraulic
chuck magnetic
Panel with automatic cycle selector (AUT)
Independent drill tank with pump
Year: 2002
Typical applications
grinding mold and matrix plates, surface recovery in maintenance, square and parallel block, and flat parts finish after heat treatment.
See her in Ferrotall
The machine is located in our facilities of Monforte del Cid (Alicante), where you can visit it; contact us to see it running or receive a video. Our own technical service is responsible for transport, installation and start-up.
The Kair TMA-800 × 400 is a grinding machine of flat surfaces of tangential type, with a hydraulically activated alternative motion table. It is used to obtain planitude, parallelism and good finish in tempered or untempered steel parts: mould and matrix plates, guides, recesses, flanges, blades and utilages.
Strong points of this machine
In the tangential rectification the grinding wheel works with its periphery, which allows narrow tolerances of planitude and a fine finish. The hydraulic drive of the table gives a smooth and adjustable displacement. The panel of this unit includes automatic selector (AUT) and transverse advance and grinding wheel. descent controls (Z7Z.)
Configuration of this unit
Model: TMA-800 × 400
Maximum grinding area: 800 × 400 mm
travel longitudinal (X): 940 mm
grinding wheel: 250 × 40 mm
Table operation: hydraulic
chuck magnetic
Panel with automatic cycle selector (AUT)
Independent drill tank with pump
Year: 2002
Typical applications
grinding mold and matrix plates, surface recovery in maintenance, square and parallel block, and flat parts finish after heat treatment.
See her in Ferrotall
The machine is located in our facilities of Monforte del Cid (Alicante), where you can visit it; contact us to see it running or receive a video. Our own technical service is responsible for transport, installation and start-up.
Listing text machine-translated into English from Spanish. Make and model are as supplied by the dealer.
Imported from the Ferrotall Maquinas Herramienta S.L. stock feed (https://www.ferrotall.com/products.json). Source listing: https://www.ferrotall.com/en/products/rectificadora-kair-tma-800x400
