Home / Metal cutting / Turning (Automatics, Borers and Lathes) / Fully Refurbished Colchester Triumph 2000 30'' Straight Bed Lathe






Fully Refurbished Colchester Triumph 2000 30'' Straight Bed Lathe
Technical specification
| Category | Turning (Automatics, Borers and Lathes) |
| Make | Colchester |
| Condition | Used |
| Location | United Kingdom |
Description
Fully Refurbished Colchester Triumph 2000 30'' Gap Bed Lathe
Height of Centres 190mm
Max’ Distance Between Centres 762mm
Max’ Swing over Bed 390mm
Max’ Swing over Cross Slide 240mm
Spindle Bore 54mm
Spindle Nose D16 Camlock
Spindle Taper in Bush No.4 Morse
Spindle Speeds 25 - 2000 rev/min
Tailstock No.4 Morse
3 Phase Electrics
7.5hp Motor
Supplied with:
3 Jaw Chuck
Quick Change Tool Post
DRO
Work completed
Fully stripped down
Gears and shafts cleaned and changed if required.
Full clutch service
Lubrication system fully cleaned up
Feed cleaned and bearings changed
Apron gear box cleaned out and serviced
Feed sleeves and seals changed
Bed removed and rebedded and dowelled
Bed ground
Tursite to the saddle
Regrind saddle, cross slide and shoes
Compound slide reground
Tailstock split and realigned
Base scraped into bed section
Saddle and cross slide scrapped in
New screws and nuts where required
New half nuts and lead screw
Fully repainted
New slight glasses and legends
New DRO
New chuck guard
New light
Test cut along 10’’ to 1/10th thou from end to end
Realign tailstock to ½ thou
Height of Centres 190mm
Max’ Distance Between Centres 762mm
Max’ Swing over Bed 390mm
Max’ Swing over Cross Slide 240mm
Spindle Bore 54mm
Spindle Nose D16 Camlock
Spindle Taper in Bush No.4 Morse
Spindle Speeds 25 - 2000 rev/min
Tailstock No.4 Morse
3 Phase Electrics
7.5hp Motor
Supplied with:
3 Jaw Chuck
Quick Change Tool Post
DRO
Work completed
Fully stripped down
Gears and shafts cleaned and changed if required.
Full clutch service
Lubrication system fully cleaned up
Feed cleaned and bearings changed
Apron gear box cleaned out and serviced
Feed sleeves and seals changed
Bed removed and rebedded and dowelled
Bed ground
Tursite to the saddle
Regrind saddle, cross slide and shoes
Compound slide reground
Tailstock split and realigned
Base scraped into bed section
Saddle and cross slide scrapped in
New screws and nuts where required
New half nuts and lead screw
Fully repainted
New slight glasses and legends
New DRO
New chuck guard
New light
Test cut along 10’’ to 1/10th thou from end to end
Realign tailstock to ½ thou
Imported from the Sparx Machine Tools Ltd stock feed (https://www.sparxmachinetools.co.uk/products.json). Source listing: https://www.sparxmachinetools.co.uk/products/fully-refurbished-colchester-triumph-2000-30-gap-bed-lathe
