




Bench grinder Letag E-4
Technical specification
| Category | Grinders |
| Make | ferrotall-nuevo |
| Condition | Used |
| Location | Spain |
Description
What is it?
The Letag E-4 is a standing emerilator with two teeth, one on each side of the engine, for tool sharpening and cutting of parts in machining and maintenance workshop. Letag is a Spanish esmerilator manufacturer.
Strengths
According to the plate, it supports teeth up to 225 mm in diameter and 30 mm width. when going on pedestal, it works at operator height without the need for a bench. (Z3Z.)
Configuration of this unit
Model: Letag E-4 (plate)
Serial No: 60876 (plate)
Engine: 1,1 CV, 2.850 rpm, 50 Hz (plate)
voltage: 220-380 V, 3-1,73 A (plate)
Maximum grinding wheel: Ø 225 mm x 30 mm width (plate)
Pedestal, rotating switch on the body and transparent protective screens (photos)
Flexible vacuum tubes visible in the photos
Typical applications
Shared of brocches, chisels and buriles, brazed of welded or cut parts and reviewed of hand tools in workshops, locks and maintenance departments.
See her in Ferrotall
The machine is located in our facilities of Monforte del Cid (Alicante), where you can visit it; contact us to see it running or receive a video. Our own technical service is responsible for transport, installation and start-up.
The Letag E-4 is a standing emerilator with two teeth, one on each side of the engine, for tool sharpening and cutting of parts in machining and maintenance workshop. Letag is a Spanish esmerilator manufacturer.
Strengths
According to the plate, it supports teeth up to 225 mm in diameter and 30 mm width. when going on pedestal, it works at operator height without the need for a bench. (Z3Z.)
Configuration of this unit
Model: Letag E-4 (plate)
Serial No: 60876 (plate)
Engine: 1,1 CV, 2.850 rpm, 50 Hz (plate)
voltage: 220-380 V, 3-1,73 A (plate)
Maximum grinding wheel: Ø 225 mm x 30 mm width (plate)
Pedestal, rotating switch on the body and transparent protective screens (photos)
Flexible vacuum tubes visible in the photos
Typical applications
Shared of brocches, chisels and buriles, brazed of welded or cut parts and reviewed of hand tools in workshops, locks and maintenance departments.
See her in Ferrotall
The machine is located in our facilities of Monforte del Cid (Alicante), where you can visit it; contact us to see it running or receive a video. Our own technical service is responsible for transport, installation and start-up.
Listing text machine-translated into English from Spanish. Make and model are as supplied by the dealer.
Imported from the Ferrotall Maquinas Herramienta S.L. stock feed (https://www.ferrotall.com/products.json). Source listing: https://www.ferrotall.com/en/products/esmeriladora-letag-e-4
